Chemical Forums

Specialty Chemistry Forums => Citizen Chemist => Topic started by: Frater EIE on May 16, 2017, 08:51:18 PM

Title: Lab clamp sleeve
Post by: Frater EIE on May 16, 2017, 08:51:18 PM
Hey

Not sure if this is the right forum, but the cork pads fell off my 2-prong lab clamp. What I'm considering is just buying some silicone kapton tape and wrapping it around the prongs, to give padding and heat protection. Any thoughts?
Title: Re: Lab clamp sleeve
Post by: P on May 17, 2017, 04:30:18 AM
That or just glue the cork back on. PVA glue? You can get high temp glues also or maybe an epoxy?...  or just tape them on like you suggested.