April 20, 2024, 03:58:20 AM
Forum Rules: Read This Before Posting


« previous next »
Pages: 1 [2]   Go Down

Topic: Volumetric analysis  (Read 16305 times)

0 Members and 1 Guest are viewing this topic.

Offline Mitch

  • General Chemist
  • Administrator
  • Sr. Member
  • *
  • Posts: 5298
  • Mole Snacks: +376/-3
  • Gender: Male
  • "I bring you peace." -Mr. Burns
    • Chemistry Blog
Re:Volumetric analysis
« Reply #15 on: December 23, 2004, 03:57:25 AM »
NO!

You are neutralizing the moles of HCl. If you add water does this change the moles of HCl present in the flask?
Logged
Most Common Suggestions I Make on the Forums.
1. Start by writing a balanced chemical equation.
2. Don't confuse thermodynamic stability with chemical reactivity.
3. Forum Supports LaTex

chemistrie

  • Guest
Re:Volumetric analysis
« Reply #16 on: December 23, 2004, 05:53:40 AM »
Then it's the number of moles of the two substances that matter most, not necessarily of their concentrations?

We can determine the number of moles simply by referring to a balanced chemical equation?
Logged

Offline Mitch

  • General Chemist
  • Administrator
  • Sr. Member
  • *
  • Posts: 5298
  • Mole Snacks: +376/-3
  • Gender: Male
  • "I bring you peace." -Mr. Burns
    • Chemistry Blog
Re:Volumetric analysis
« Reply #17 on: December 23, 2004, 05:57:28 AM »
moles is all that matters. Looking at a balanced chemical equation will tell you nothing about the amount of moles in an unknown, unless you do an experiment to determine it.
Logged
Most Common Suggestions I Make on the Forums.
1. Start by writing a balanced chemical equation.
2. Don't confuse thermodynamic stability with chemical reactivity.
3. Forum Supports LaTex
Pages: 1 [2]   Go Up
« previous next »
Sponsored Links