Chemical Forums

Please login or register.

Login with username, password and session length

Sponsored links

Pages: [1]   Go Down

Author Topic: Lab clamp sleeve  (Read 855 times)

0 Members and 1 Guest are viewing this topic.

Frater EIE

  • Regular Member
  • ***
  • Mole Snacks: +0/-0
  • Offline Offline
  • Posts: 11
  • Alchemist
Lab clamp sleeve
« on: May 16, 2017, 02:51:18 PM »

Hey

Not sure if this is the right forum, but the cork pads fell off my 2-prong lab clamp. What I'm considering is just buying some silicone kapton tape and wrapping it around the prongs, to give padding and heat protection. Any thoughts?
Logged

P

  • Full Member
  • ****
  • Mole Snacks: +53/-15
  • Offline Offline
  • Gender: Male
  • Posts: 564
  • I am what I am
Re: Lab clamp sleeve
« Reply #1 on: May 16, 2017, 10:30:18 PM »

That or just glue the cork back on. PVA glue? You can get high temp glues also or maybe an epoxy?...  or just tape them on like you suggested.
Logged
Tonight I’m going to party like it’s on sale for $19.99!

- Apu Nahasapeemapetilon

Pages: [1]   Go Up
 

Mitch Andre Garcia's Chemical Forums 2003-Present.

Page created in 0.068 seconds with 23 queries.