March 29, 2024, 05:49:50 AM
Forum Rules: Read This Before Posting


Topic: Cleaning ferrite oxide  (Read 2566 times)

0 Members and 1 Guest are viewing this topic.

Offline Kiitos

  • Very New Member
  • *
  • Posts: 1
  • Mole Snacks: +0/-0
Cleaning ferrite oxide
« on: October 25, 2018, 03:45:55 PM »
With which solution could I clean ferrite oxide from rubber?
It's used on pinch roller in tape deck.
Thanks

Offline Borek

  • Mr. pH
  • Administrator
  • Deity Member
  • *
  • Posts: 27634
  • Mole Snacks: +1799/-410
  • Gender: Male
  • I am known to be occasionally wrong.
    • Chembuddy
Re: Cleaning ferrite oxide
« Reply #1 on: October 26, 2018, 03:13:07 AM »
Not sure what you mean by "ferrite oxide" - no such thing. I assume you mean some mixture of iron oxides.

I would start with just some detergent, oxides are often in a dust form so at least some of it should go away.

Then, citric acid is a reasonably safe option.

Finally, hydrochloric acid could do the trick, but when dealing with acids there is always a risk they will destroy whatever you are trying to clean up. Depending on what is going on it can be better to leave the oxide as it is than to try to remove it. I would try with 1% acid first, to see if it works at all. 3% if the 1% is not satisfactory. Higher concentrations sound a bit risky.

Don't forget to rinse the surface with large amounts of water.
ChemBuddy chemical calculators - stoichiometry, pH, concentration, buffer preparation, titrations.info

Sponsored Links