Chemical Forums
Specialty Chemistry Forums => Biochemistry and Chemical Biology Forum => Topic started by: lufthoved on August 11, 2005, 06:35:09 AM
-
Hi everyone...
Im working with DNA and PCR and wanted to test my amplicons. Therefore I made a gel.
Actually it turned out very good but I was wondering how to improve my result.
1. There a large white shadow behinds my band (Im using EtBr and dye). How can I reduce this (or better yet remove it)?
2. Should I run longer time, so the bands will end up post the shadow?
Pardon my english (I come from Denmark)...
Best wishes
lufthoved
-
i think you need to run longer
-
You think the band will be better then, and the shadow smaller?
-
1.You can try to reduce the amount of ethBr.
2.Sometimes is it enough to clean the photo-table.
3.Running the gel longer makes no sense in my opinion.
best wishes kira
-
Hi, all. Thank you for your answers.
I was wondering if it would be better could mix EthBr with the samples and apply to the wells instead of mixing in the gel?