Chemical Forums
Chemistry Forums for Students => Analytical Chemistry Forum => Topic started by: Friholio on January 19, 2018, 04:59:10 PM
-
So the transport assembly on my lab's Agilent 1100 G1313A autosampler (older than dirt, I know) has s#*$ the bed. In the meantime we would like to still run samples through the HPLC via manual injections. I cannot seem to find any information on how to set that up in our HP ChemStation (version A.08.03) software. Anyone know how to accomplish this?
-
Now that you mention it, I've never seen a manual injector on an 1100.
The model before the 1100 had the manual injector as part of the column heater assembly. As a start, try looking over the column heater to see if you can find a manual injector somewhere there.
Good luck.
-
We have often used manual injections on our 1100. Is your question about software or hardware?