March 28, 2024, 06:32:16 PM
Forum Rules: Read This Before Posting


Topic: Recrystallization Solvent ?  (Read 1321 times)

0 Members and 1 Guest are viewing this topic.

TrevorGage

  • Guest
Recrystallization Solvent ?
« on: March 18, 2020, 01:28:32 AM »
What to recrystallize methyl 3,5-dibromobenzoate from?

Literature says ethanol but it doesn't work. Compound precipitates and does not crystallize.

Melting point is 63 C.

I have also tried DCM, or DCM/hexane and the same thing happens.
« Last Edit: June 22, 2021, 05:22:14 AM by Borek »

Offline hollytara

  • Chemist
  • Full Member
  • *
  • Posts: 317
  • Mole Snacks: +39/-0
Re: Recrystallization Solvent ?
« Reply #1 on: March 18, 2020, 08:56:34 AM »
You get a powder (microcrystals) instead of discernible crystals? 

I always like to recrystallize methyl esters from methanol if using an alcohol - no chance of transesterification.

If you are getting a powder, that means the temperature/solubility curve is very steep - so you can suddenly become greatly oversaturated and have rapid crystallization. 

You can - dissoive to saturation at room temperature.  Then add a known amount of extra material - don't saturate at hgh T. 

Or - lower the temperature more slowly. 

Offline pgk

  • Chemist
  • Full Member
  • *
  • Posts: 892
  • Mole Snacks: +97/-24
Re: Recrystallization Solvent ?
« Reply #2 on: March 18, 2020, 01:46:48 PM »
Try recrystallization with ethanol containing a little THF. It may work.

barbarahansen

  • Guest
Re: Recrystallization Solvent ?
« Reply #3 on: January 12, 2021, 09:59:31 AM »
The precipitate was collected by filtration and recrystallized from a mixture of ethanol and water.
« Last Edit: June 22, 2021, 05:22:25 AM by Borek »

Offline jeffmoonchop

  • Full Member
  • ****
  • Posts: 334
  • Mole Snacks: +37/-5
  • Gender: Male
Re: Recrystallization Solvent ?
« Reply #4 on: January 12, 2021, 12:04:11 PM »
Are you doing it by antisolvent method? may be too rapid. Dissolve in minimum amount of solvent at an elevated temp. Cool the solution slowly. You may need to hold the solution at a temp for a long time if its not crystallizing by primary nucleation. If you know the solubility cool to just below the solubility and hold, try scratching the solution with a sharp object to encourage heterogeneous nucleation. Or leave the sharp object suspended so it has something to grab onto when it decides to go. When it does go the nucleation rate will be low because the supersaturation is low, then you're more likely to grow onto existing nuclei, rather than forming many nuclei (powder).

Offline jeffmoonchop

  • Full Member
  • ****
  • Posts: 334
  • Mole Snacks: +37/-5
  • Gender: Male
Re: Recrystallization Solvent ?
« Reply #5 on: January 12, 2021, 12:06:11 PM »
Also, once it is growing, you can start to decrease the temp again (slowly) to get more material out of solution to maximize yield

Sponsored Links