March 28, 2024, 05:32:07 AM
Forum Rules: Read This Before Posting


Topic: TLC Question  (Read 931 times)

0 Members and 1 Guest are viewing this topic.

Offline swissroll

  • Very New Member
  • *
  • Posts: 2
  • Mole Snacks: +0/-0
TLC Question
« on: September 19, 2021, 09:10:02 PM »
Question is written below. I am confused because the eluan is not dissolved in a solvent so the question does not make sense to me.

When spotting compounds on a TLC plate, do the compounds have to be dissolved in the same solvent as the eluant? Why or why not?

Am I overthinking it?

Offline wildfyr

  • Global Moderator
  • Sr. Member
  • ***
  • Posts: 1771
  • Mole Snacks: +203/-10
Re: TLC Question
« Reply #1 on: September 19, 2021, 09:28:45 PM »
For spotting, you just need to transport it on there and make a nice small concentrated spot. So whatever solvent will work is what you use. Usually its something like ethyl acetate or acetone. Typically the spotting solvent then evaporates off before you actually run the TLC

Offline swissroll

  • Very New Member
  • *
  • Posts: 2
  • Mole Snacks: +0/-0
Re: TLC Question
« Reply #2 on: September 19, 2021, 09:41:21 PM »
Thank you.

Offline rolnor

  • Chemist
  • Sr. Member
  • *
  • Posts: 2203
  • Mole Snacks: +148/-10
Re: TLC Question
« Reply #3 on: September 20, 2021, 01:37:15 AM »
High boiling, polar solvents like DMF or DMSO needs to be evaporated before running the plate, this can be done with a heating-gun or hair-dryer.

Offline Babcock_Hall

  • Chemist
  • Sr. Member
  • *
  • Posts: 5594
  • Mole Snacks: +319/-22
Re: TLC Question
« Reply #4 on: September 20, 2021, 08:34:36 AM »
@OP,

What are two properties of acetone that make it useful in TLC spotting.  What other solvents have one of these two properties?

Offline Meter

  • Full Member
  • ****
  • Posts: 254
  • Mole Snacks: +14/-3
  • Take what I say with a grain of salt
Re: TLC Question
« Reply #5 on: September 20, 2021, 09:17:29 AM »
You want a volatile solvent where even trace amounts won't interact significantly with the eluent. This can be achieved by either drying your spots with a heating gun or even better, rotavapping your sample and redissolving it in an appropirate solvent. I had trouble with trace THF interacting with my eluent in TLC, so that's where I'm drawing my experience from.

Sponsored Links