Specialty Chemistry Forums > Other Sciences Question Forum

HCL and H20

(1/2) > >>

RLA_100:
Just a question i've always wondered.
Since HCL + H20 dissassociates 100% into H30 and CL-  than theortically if you had pure HCL and poured it on your skin it would do no damage?

Also how the more water you add the less acidic it is, dosen't more water allow more Hyrdonium Ions to form?

AWK:
Boiling point of pure HCl is -85 C. How would you pour it on you skin?

the more water - the more diluted solution of hydronium ions.

jdurg:
More water will allow more hydronium ions to form, but only if there is more acid available to form the hydronium ions.  If you have four moles of HCl in 5 moles of water, adding more water won't create more HCl.  Acidity is determined by the concentration of hydronium ions in a solution, and adding more water only dilutes the concentration, thus reducing the acidity.  Also, if you had pure HCl and poured it on your skin, first off the very low temperature of the liquid HCl would caused a lot of damage to your skin, and the HCl would also draw water out of your skin causing a lot of damage.  It's the same principal as if you spilled powdered NaOH on your skin.

RLA_100:
Hi thank you for respond,

So if you have 4 mol's of HCL and add 1 mol of H20 the acidty wont' be as high as if you had 4 mol HCL and 4 mol H20?

AWK:
In this case acidity will be almost the same since you can dissolve only about 1/3 mole of HCl in 1 mole of water at RT. Highest pressure of HCl over solution increase solubility of HCl (and pH) insignificantly for the first case.
But if you take 4 mole of HCl for 1 L of water or 4 mole of HCl for 4 L of water the difference of pH will be about 0.6 unit.

Navigation

[0] Message Index

[#] Next page