March 28, 2024, 02:02:34 PM
Forum Rules: Read This Before Posting


Topic: About the stability of alkene!  (Read 6781 times)

0 Members and 1 Guest are viewing this topic.

Offline Winga

  • Chemist
  • Full Member
  • *
  • Posts: 510
  • Mole Snacks: +39/-10
About the stability of alkene!
« on: November 10, 2004, 08:12:32 AM »
By Saytzeff's rule, the greater no. of alkyl groups attached to the double bonded carbons, more stable the alkenes.

Can I say that the double bonded carbons are said to be e- deficient?
So, the e- donating groups, alkyl groups can stabilize C=C carbons. By hyperconjugation?

I want to know that the bond pair e- in C-H bond (sigma orbital) donates to which orbital of C=C so that C=C carbons can be stabilized.


One more factor to explain more alkyl groups attached to C=C carbons, more stable the alkenes is the bond strain, right?

Offline Mitch

  • General Chemist
  • Administrator
  • Sr. Member
  • *
  • Posts: 5298
  • Mole Snacks: +376/-3
  • Gender: Male
  • "I bring you peace." -Mr. Burns
    • Chemistry Blog
Re:About the stability of alkene!
« Reply #1 on: November 10, 2004, 04:38:46 PM »
What does stable really mean? I hate these types of words. If stability was defined by which one has a lower (delta)Hformation then the lone ethylene would have the lowest and thus be most "stable".
Most Common Suggestions I Make on the Forums.
1. Start by writing a balanced chemical equation.
2. Don't confuse thermodynamic stability with chemical reactivity.
3. Forum Supports LaTex

dexangeles

  • Guest
Re:About the stability of alkene!
« Reply #2 on: November 10, 2004, 10:54:19 PM »
yes Zaitsev's rule states that, meaning

Stability:

monosubstituted < disubstituted < trisubstituted < tetra substituted
(less stable)                                                       (more stable)

then you have to factor out cis vs trans (steric hindrace/strain)
trans is usually more stable than cis except for cycloalkenes
trans is said to only appear in cylcooctene and above, but is still less stable than cis
around 12C ring, their approximately equal, then over 12 trans is more stable

and yes, hyperconjugation affects it's stability more than induction effect

it would be better to say that double bonds are electron attracting than e- deficient

their stability can be shown through their potential energy map
the lower the potential energy, the more stable

bond strains in double bonds are prominents in cycloalkenes

e.g.
the Carbon is sp2 hybridized, so the angles between bonds are said to be around 120 degrees
in cyclobutene (in example) the bond in the cycloalkene is at 90 degrees
this is a cause of angle strain and makes it not stable

Offline Winga

  • Chemist
  • Full Member
  • *
  • Posts: 510
  • Mole Snacks: +39/-10
Re:About the stability of alkene!
« Reply #3 on: November 11, 2004, 08:00:14 AM »
Do alkyl groups donate e- by hypercojugation + inductive effect or just hyperconjugation?

dexangeles

  • Guest
Re:About the stability of alkene!
« Reply #4 on: November 11, 2004, 12:12:14 PM »
inductive effect is the effect (pull) that more electronegative atoms have on other electrons from other sites of the molecule, so i'd say hyperconjugation

Sponsored Links