[AhmedEzatAlzawalaty]

How does the conductimeter measure conductivity? i think that it cannot be measured?
does it really measure conductivity or somethin else that can be related to conductivity?

[ARGOS++]

Dear ahmedezat,

I’m really assured that you know; Conductivity needs a current to be measured,
so you may got problems with electrolysis and polarisation potential, I think.
To avoid this “unlike”, misleading effects the industry uses “alternate current”
of low frequency (Common 50 Hz or 100Hz OR 60Hz or 120Hz; Why?).
For more comparable measurements often 500Hz has been “standardised”.

But keep care, it’s a method, which is influenced by several parameters, like
Temperature, Water-quality, and of course Frequency (Why again?), ?etc.?.
Don’t forget the blank, it’s a method it depends very strong on!

Question: By what concentration is the Conductivity a maximum?

Good Luck!
                    ARGOS⁺⁺

[AhmedEzatAlzawalaty]

I think by high concentration of minerals in water am i right?

[ARGOS++]

Dear ahmedezat,

I would have to say: YES,  ? But ONLY in case IF I prefer to be satisfied with HALF
of the answer.
A Maximum, of course a Minimum too, must have a “LEFT side” AND a “Right side”, too!!
You can do it easier, if you start your answer for this Type of Questions like:
 “The mobility of humans is increasing with “building more cars”, TILL ……  becomes more
   important , which lowers the human mobility again.”

Of course any similar recipe will do it, too!

Good Luck!
                    ARGOS⁺⁺