October 13, 2024, 09:05:41 AM
Forum Rules: Read This Before Posting


Topic: Help w/ Magnesium combustion lab ratio  (Read 7176 times)

0 Members and 1 Guest are viewing this topic.

abhar

  • Guest
Help w/ Magnesium combustion lab ratio
« on: January 09, 2005, 06:53:19 PM »
I am doing a lab on the combustion of magnesium.  We heated magnesium in a crucible over a bunsen burner until it became MgO.  We know the actual chemical formmula was MgO, but our mass measurements eventually gave us the formula Mg2O, but our teacher said it was ok.  

There is a question that says:
Suppose that you had allowed some magnesium oxide smoke to escape during the investigation.  How would the Mg:O ratio have been affected?  Would the ratio increase decrease or remain unchanged.  Explain using sample calculations.  

I don't understand??  If it is magnesium oxide gas that it escaping, why would the ratio change?  Am I correct?

Offline kevins

  • Chemist
  • Full Member
  • *
  • Posts: 176
  • Mole Snacks: +17/-6
  • I'm a llama!
Re:Help w/ Magnesium combustion lab ratio
« Reply #1 on: January 10, 2005, 10:38:16 AM »
When Mg burn in air, both MgO and Mg2N3 are form. Therfore if you count all the final products are MgO, then the ratio should have a little bit different.

Tetrahedrite

  • Guest
Re:Help w/ Magnesium combustion lab ratio
« Reply #2 on: January 11, 2005, 11:10:07 PM »
If you did the experiment on a humid day there is a strong chance that brucite-Mg(OH)2 was formed as well, which could explain the ratio

Sponsored Links