December 10, 2024, 04:34:34 PM
Forum Rules: Read This Before Posting


Topic: loss on drying of tripotassium citrate monohydrate  (Read 3515 times)

0 Members and 1 Guest are viewing this topic.

Offline thermoman

  • New Member
  • **
  • Posts: 7
  • Mole Snacks: +0/-0
loss on drying of tripotassium citrate monohydrate
« on: October 15, 2012, 01:54:41 PM »
I'm having a problem with the loss on drying test of tripotassium citrate monohydrate.
The specification is between 3.0-6.0% after drying for 4h at 180c. The result I'm getting is about 2.1%. This batch was tested a year ago and the result was 4.9%. I have done the test twice, and got the same result. when I'm trying to determine the assay on dry basis , I'm getting a result of about 100.1% with the L.O.D result of 4.9 and about 97% (out of spec)  with the L.O.D result of 2.1%.
what am I doing wrong?
I hope the massage is clear.

Offline Stepan

  • Chemist
  • Full Member
  • *
  • Posts: 358
  • Mole Snacks: +39/-4
  • Gender: Male
  • Air Chemistry Man
    • Supplier of air sampling equipment and services
Re: loss on drying of tripotassium citrate monohydrate
« Reply #1 on: October 16, 2012, 06:56:34 AM »
Try to take a sample from different part of the storage container - close to the middle. It might happens that top layer adsorbed CO2 and potassium carbonate doesn't want to brake down at 180C. If this is a case: a) contamination is more pronounced on the layer of citrate which exposed to air - on the surface. b) dissolve small portion of salt in water and add acid to resulting solution acidity below pH 3, you should observe bubbling of CO2.

Offline curiouscat

  • Chemist
  • Sr. Member
  • *
  • Posts: 3006
  • Mole Snacks: +121/-35
Re: loss on drying of tripotassium citrate monohydrate
« Reply #2 on: October 16, 2012, 08:44:27 AM »
I hope the massage is clear.

I rather hope not.. ;)

Sponsored Links