Specialty Chemistry Forums > Chemical Engineering Forum
Friction factor Q
(1/1)
gera19:
See Q 1b
i used the formula for change in pressure=2Cf X density X velocity^2 X L/d but there are simply too many unknowns. Pls help.
Donaldson Tan:
Can you type the question out instead posting the PDF?
It will be easier for all of us to view the question.
Donaldson Tan:
I assume you are using the Fanning Friction Factor because this is a chemical engineering problem.
However, this is not required to solve the problem. You only need to find the frictional loss (in energy).
The original bernoulli equation (see above) does not take in account of energy input and friction losses.
I have modified it to answer the question. It is still the same principle being used to solve the problem, ie. the first law of thermodynamics: conservation of energy.
energy in = energy out
uin2/2 + ghin + Pin/? + Wpump = uout2/2 + ghout + Pout/? + Floss
uin2/2 + Pin/? + Wpump = uout2/2 + g(hout - hin) + Pout/? + Floss
where Floss is the frictional loss and Wpump is energy supplied by pump to soybean oil
Since the exit and entrance pipes are of the same diameter, mass flow rate is constant and the soybean oil is incompressible, then the velocity of the oil must remain constant, ie. uin = uout = u
This means the above equation reduces to:
Pin/? + Wpump = Pout/? + Floss + g(hout - hin)
Floss = Wpump - g(hout - hin) - (Pout - Pin)/?
Navigation
[0] Message Index
Go to full version