October 15, 2019, 08:15:30 AM
Forum Rules: Read This Before Posting


Topic: Aligning substrates for observation under a metallurgical microscope.  (Read 965 times)

0 Members and 1 Guest are viewing this topic.

Offline 0xFFFF

  • New Member
  • **
  • Posts: 8
  • Mole Snacks: +1/-0
  • Chemistry amoeba
What would be the correct procedure for aligning a silicon die so it is parallel to the front lens element?

I've been looking at z tilt platforms but I'm not sure if this is the right approach?

One thing I have not tried yet is pressing the die on to a slide with an optical adhesive. I'm not sure if this will work but just for giggles I'm going to give it a shot.

Sponsored Links